A paper jam is annoying, but it's one of the easiest printer problems to fix. The key is patience: pulling paper out too fast or in the wrong direction is what causes real damage.

Before You Start

  • Turn the printer off and unplug it from the wall. Laser printers have a fuser that reaches very high temperatures — give it a few minutes to cool down before reaching inside.
  • Wash your hands or use clean dry hands — oils and moisture can damage print rollers.
  • Never use scissors, tweezers, or sharp tools near the paper path.

Finding the Jam

Most modern printers display a diagram on the screen or LED panel showing where the jam is. Check these common locations in order:

  1. Rear access door — Many printers have a removable panel at the back. Open it and look for crumpled paper.
  2. Front input tray — Pull the paper tray out completely and look underneath for torn scraps.
  3. Inside the printer (top access) — Lift the scanner lid or top cover to expose the paper path.
  4. Duplex unit — If your printer does double-sided printing, there's often a separate duplex door on the back.

Removing the Paper

Once you locate the jammed paper, grip it with both hands and pull slowly and evenly in the direction the paper would normally travel (usually forward and out). Never yank upward or against the paper path. If it tears, remove every last scrap — even a small piece left behind will cause the next jam.

For laser printers, check around the fuser (the roller assembly near the paper exit). This area may still be warm. Pull gently and don't touch the shiny rollers directly with your fingers.

After Clearing the Jam

  1. Check the entire paper path for torn fragments — use a flashlight if needed.
  2. Reload fresh paper, making sure the stack is square, not overfilled, and the guides are snug but not pinching the paper.
  3. Plug the printer back in, power it on, and let it run its startup cycle.
  4. Print a test page before sending a real job.

Jams that keep coming back often mean dirty or worn paper-feed rollers. Ask us if you're dealing with repeated jams.